Mettler TENS 212 Digital 2 Channel Tens
Over The Counter ~ No Prescription Needed
Digital Tens with LCD Display
The TENS 212 is a two channel digital TENS device that provides continuous, modulated and burst modes.
Pulse frequency and width may be set independently.
The large LCD display is easy to see from any angle and provides a visual of all your waveform parameters.
- Each unit comes with a carrying case, set of four V-Trode™ self-adhesive electrodes, a 9 volt battery and instructions.
- Weight: 5 oz. (140 grams), battery included
- Dimensions: 4.25″ (H) x 2.4″ (W) x 1″ (T), (108 mm (H) x 61.5 mm (W) x 25 mm (T))
- Warranty: 1 year on unit, 90 days on accessories
Channel: Dual, isolated between channels
Pulse intensity: Adjustable 0-80 mA peak into 500 Ω load each
channel, constant current
Pulse Rate: 1Hz-160 Hz (adjustable), 1Hz/step (1-20 Hz), 5Hz
/ step (20-160 Hz)
Pulse Width: 50 μs – 260 μs (adjustable), 10 μs/steps
Shows the treatment times in hours.
Timer: 15, 30, 60 minutes and continuous mode
LCD: Shows modes, pulse rate (frequency), pulse width,
B: Cycle Bursts, 2 Bursts/sec, 9 pulses / Burst, 100 Hz, width is adjustable.
C: Continuous mode. Pulse rate, pulse width and intensity are adjustable.
M: Modulated Width. Pulse width is automatically varied in an interval of 6
seconds. The modulation range of pulse width is from setting value to 35%
less than the control setting value, then returns to the setting value. Rate,
width and intensity are fully adjustable.
Wave form: Asymmetrical Biphasic square pulse
Voltage: 0-110 Volts (Open Circuit)
Max charge per pulse: 21 micro-coulombs
Power Source: 9-Volt Battery
Dimensions: 4.25" (H) × 2.4" (W) × 1" (T), (108 mm (H) ×61.5 mm (W) ×25
Weight: 5 oz. (140 grams), battery included
All electrical specifications are ±10% 500 Ω load